EvanPhilip
New Member
I have been reading/listing to all the halo books at work last summer and tried to build some pep helmet a few years back. I never did finish it so with all the new free time I had this summer I wanted to start an ODST build. I've looked and read a lot of threads. I started out building the legs and arms and the chest, however, using just hot glue for everything was kinda a bad idea. I tried contact cement and works well but to wait 15 mins to glue a part would take years, and super glue is nice till your fingers stick together. I really ended up choosing fast and cheap instead of good and cheap, even though it's probably gonna be a lot more then I think after all the mistakes and whatnot I will have.
The first picture is me just trying different paint and what covers up the most. I used flex seal and its just one or two coats.
The second one is just like 7 or 8 coats of plastic dip.
The third is the forearms and thought the size was right but might be to big and the top detail I might 3d print since I have no idea hot to get that small of detail.
The forth is the first shoulder I ever made and the right side is the 4th shoulder.
The first picture is me just trying different paint and what covers up the most. I used flex seal and its just one or two coats.
The second one is just like 7 or 8 coats of plastic dip.
The third is the forearms and thought the size was right but might be to big and the top detail I might 3d print since I have no idea hot to get that small of detail.
The forth is the first shoulder I ever made and the right side is the 4th shoulder.