Reply to thread

I’ve seen similar results of the resin top coat idea. I’ve not don’t it yet myself but in research I’ve seen tests that show yes it keeps it from warping pretty well in heat but should there be blunt force trauma that damage the resin layer it reveals that the pla underneath still gets soft. It just can’t deform inside it’s hard shell of resin unless the resin itself gets deformed or damaged


This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top