Reply to thread

Yeah start with low grit and move up. i personally do spot putty on seams then up to 220. then ill do a coat of filler primer and then sand that at 220 and recoat with filler primer as needed. once im happy with it ill wet sand at 1500 before final paint. this is a mando bucket i did last year


This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top