Reply to thread

I use “rust-oleum automotive primer 2in1 filler and sandable” with my prints and always finish with a coat of that then 400 grit sand then proceed to paint and clear coat! Makes for a very smooth piece!


This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top