Reach armour ability module print

stuffinstuff

New Member
I made a 3d print model for Halo Reach's armour ability module. I made it to fit wiring and LEDS but I haven't tested it out. If you decide to print it out, you should probably use a layer height of 0.1 mm or lower to keep all the details.

STL is in attachments

Printed:

20230330_215747.jpg
20230330_215813.jpg
20230330_215758.jpg
20230330_215806.jpg
 

Attachments

  • armourability1.stl
    1.1 MB · Views: 161
Awesome job! I might be using this for my build! What program did you use to model it?
 
This thread is more than 9 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top