Spiderboy196

Active Member
Now that I finished a based mk7 mp spartan, time to resume my second reach suit for halo infinite and reach in general as a Helljumper spartan.
Before infinite stuff came out, I had already completed a set of shins, boots, biceps and forearms. Now all I have left to do is the chest, thighs, waist, and shoulder/chest and thigh attachments.
 

Attachments

  • ODST.png
    ODST.png
    836.2 KB · Views: 24
  • 20210527_212148.jpg
    20210527_212148.jpg
    671 KB · Views: 21
  • 20210524_224246.jpg
    20210524_224246.jpg
    576.1 KB · Views: 18
  • 20210609_151837.jpg
    20210609_151837.jpg
    488.3 KB · Views: 16
  • 20210614_191211.jpg
    20210614_191211.jpg
    428.7 KB · Views: 17
  • 2336f211-4f65-47d4-94e3-7e1e70661b16.png
    2336f211-4f65-47d4-94e3-7e1e70661b16.png
    821.5 KB · Views: 18
  • 25c37083-ace1-4c65-b2a2-9ee0ff222238.png
    25c37083-ace1-4c65-b2a2-9ee0ff222238.png
    1.3 MB · Views: 19
Last edited:

S225

Member
Will be trying new stuff to this second reach suit. Like shoulder attachments and chest attachment.
I could attach some images of the mounts I'm playing around with if you like. They are designed to be 3D printed but I'm sure they could inspire a foam version if that's what you're working with.
 

Spiderboy196

Active Member
I could attach some images of the mounts I'm playing around with if you like. They are designed to be 3D printed but I'm sure they could inspire a foam version if that's what you're working with.
Sure. That sounds like a good idea
 

S225

Member
The idea I'm working with is a two part mount consisting of a hook on one part of the armor and a cutout for the hook to hold onto on the other.
Screenshot (46).png
Here the yellow is a playing the part of the hook and the pink will be the opening it slots into. Imagine the pink part is inside of a shoulder pad.
Screenshot (47).png
Screenshot (48).png
The hook slides into and then up, locking it in place. Magnets will help keep everything locked and guide the parts together.
Screenshot (49).png Screenshot (50).png Screenshot (51).png
This is the mount I designed for my hip and M6, notice the parts press together and then with help from some magnets everything gets pulled into place and locks.

It's very sturdy! With foam being much lighter I think you could pull off similar results with all the parts being foam. Magnets attached to the chest and arms that meet with any attachment might also hold if with a simple peg design instead of a hook.

Lots of other ways you could find too if this doesn't work.
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top