RWBY - Sun Wukong's Ruyi Bang and Jingu Bang Gunchucks - 3D print



Took about 4 hours to complete, ran into some hickups. It would be months before I can test print so I'm gonna go ahead and release it now. Theoretically it ca can be combined into a staff if you inbed 6mm wide or less magnets into the back of the handle.

Cavity is large enough to accommodate up to 8 chain links.

Not my best renders, but it'll do.

tbrender.jpg

tbrender_005.jpg

tbrender_008.jpg

Screenshot 2021-02-23 095050.jpg
 

Attachments

  • Screenshot 2021-02-24 063434.jpg
    Screenshot 2021-02-24 063434.jpg
    111.4 KB · Views: 21
  • Screenshot 2021-02-24 063514.jpg
    Screenshot 2021-02-24 063514.jpg
    131.1 KB · Views: 18
  • Screenshot 2021-02-24 063850.jpg
    Screenshot 2021-02-24 063850.jpg
    115.1 KB · Views: 21
  • tbrender_009.jpg
    tbrender_009.jpg
    71.5 KB · Views: 17
  • tbrender_011.jpg
    tbrender_011.jpg
    223.9 KB · Views: 19
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top