Smooth On Alternatives


Mybodyisrandy

New Member
Hey everyone! I hope you are all doing well. I have printed CarterBuilder12's awesome halo 4/5 chief helmet awhile ago and I have been sanding and priming ever since and I am proud to say after 5 or less more passes it will be ready to mold! As much as I would love to mold with smooth-on I cannot afford it right now. Is there a cheaper alternative that is just as effective as smooth on or should I start saving money now?
 

marinesniper

Active Member
im getting ready to make a mold of my chief visor and im going to try the same silicone i used on the neck deal. i will post up and let you know and post pics of it. but i have been so busy i have not had time to get this done but plan on doing it this week. yeah smooth on is a great product but can get expensive....
 
This thread is more than 8 months old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top