Reply to thread

Honestly, all the slicers aren't bad, no matter from Ultimaker to Prusca etc. But when it comes to division and you want to cut a helmet into pieces! Use Windows / 3D Builder!;) Years of experience with it have never caused any problems. (y)


This thread is more than 11 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top