Reply to thread

Message

For the 3D printer section about how to select the right printer. I was considering trying to get one instead of doing the papercraft way for some of the pieces and I had heard some stuff about creality's ender and CR series. Does anyone know which one would be preferred and where to find them online? I see a couple of CR SE, but I think the CR S5 was the one recommended in another post I read. Thanks in advance!

[QUOTE="Doc Reaper, post: 846201, member: 37075"] For the 3D printer section about how to select the right printer. I was considering trying to get one instead of doing the papercraft way for some of the pieces and I had heard some stuff about creality's ender and CR series. Does anyone know which one would be preferred and where to find them online? I see a couple of CR SE, but I think the CR S5 was the one recommended in another post I read. Thanks in advance! [/QUOTE]

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification