Reply to thread

It's rather hard to spot, however there are these dark spots (or rather an entire pool...) inside my helmet with slightly sticky, appearently unhardened epoxy resin. It's only on the right side and a little on the top dome, the left side is perfectly fine. For all those 3 segments I used the same epoxy and the same mixture, it didn't get wet during its hardening process and I did this thing in summer, which was rather hot here. This is the only part that has this problem, the rest is 100% fine from what I can tell. Also tried leaving it out in the sun with the unhardened part exposed to sunlight.

Any suggestions to fix this other than redoing the fiberglass on that spot? Maybe just slap some 2mm self-adhesive EVA foam on there and call it a day?


[ATTACH=full]353863[/ATTACH]


This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top