Vacuum forming

[Long Shot]

where do you guys order your styrene sheets from, i used to have a site written down but i cannot find it anymore.

 

[link4044]

taplastic.com

 

[Long Shot]

thanks for the link Link, what materials do you use, since they dont have polystyrene sheets i was looking at the ABS or LPDE sheets. I haven't Done any forming before so any advice is much appreciated

 

[ShadowSniper]

You should try contacting them about the polystyrene sheets or visiting a store near you if there is one. They have it at the store in Santa Rosa, CA (I think that's the name of the city), where I get it on the rare occasions that I go by there. (I'm about 330 miles away)

 

[link4044]

abs would work good