What to use to detail pepakura armour?

Status
Not open for further replies.

amdphenomx4

New Member
im probably going to get resin with glass in it already.But how can i make the edges seem more flowy.Instead of just folds?Bondo ive heard was good but anyone else have other materials?Also is resin strong without fiberglass?
 
1) You need to sand the product so you can sand more off of the edges. It says that in the tuturial.

2) Resin is strong by itself, but not nearly as strong with fiberglass. Everyone would probally suggest using fiberglass and resin.
 
razrsword said:
im probably going to get resin with glass in it already.But how can i make the edges seem more flowy.Instead of just folds?Bondo ive heard was good but anyone else have other materials?Also is resin strong without fiberglass?
If you have small peices like the helmet, it's complicated, then it is strong, but still not strong enough without glass, I'd glass the entire body, and to make it smooth, after glassing, sand it down with a sand block with paper attached to it, then re resin or if it is still strong, just paint over it.
 
Last edited by a moderator:
Status
Not open for further replies.
Back
Top