azirithdorr
New Member
Hello everyone - thanks for reading this!
I've been playing around awhile now with my Silhouette Cameo using the Pepakura for Cameo software. Following instructions found on this site, and especially using Grenex's 'The Definitive Guide to Cutting Pepakura with a Silhouette Cameo', I've managed to download my model ( the Mk. VI Normal Detail parts by Robogenesis ), scale it, print it ( on my regular printer that is ), setup my pepakura and cameo ( using the registration marks and successfully 'reading' them, and cut out my pieces.
The problem for me is that the pieces are being cut consistantly approximately 2mm to the left of where they should be. They are the correct scale and at the correct height, but shifted from the printed images to the left. I've run through the settings and program several times now with full success up to this point.
I was hoping someone might have experienced this particular issue and may have come across a solution they could suggest.
Thank you for any suggestions you might be able to throw my way!
Cheers!
I've been playing around awhile now with my Silhouette Cameo using the Pepakura for Cameo software. Following instructions found on this site, and especially using Grenex's 'The Definitive Guide to Cutting Pepakura with a Silhouette Cameo', I've managed to download my model ( the Mk. VI Normal Detail parts by Robogenesis ), scale it, print it ( on my regular printer that is ), setup my pepakura and cameo ( using the registration marks and successfully 'reading' them, and cut out my pieces.
The problem for me is that the pieces are being cut consistantly approximately 2mm to the left of where they should be. They are the correct scale and at the correct height, but shifted from the printed images to the left. I've run through the settings and program several times now with full success up to this point.
I was hoping someone might have experienced this particular issue and may have come across a solution they could suggest.
Thank you for any suggestions you might be able to throw my way!
Cheers!