many, many thanks to weeds for helping me. All I had to do was reinstall pepakura
Glad I could help!
many, many thanks to weeds for helping me. All I had to do was reinstall pepakura
Actually, you don't. But if you don't, there's no way to know how to fold, which piece is which, etc.I have a question, and it is an odd one (in my opinion). Do you need to print the pattern out on cardstock off a regular printer before you can load it into the craftrobo to cut it out?
~James
I'm having an interesting problem. On several of my pages, the majority of the pieces will cut out just fine. However, as it gets closer to the end of the sheet that's not being fed in, it seems as though the knife will travel a little too far. So, far large pieces, the end that's being fed into the cutter will be ok, but the other end will have an extra small bit of paper left on it. Is this normal? I could understand it if the whole piece was slightly off, but not that one end.
I followed the instructions exactly as described in the video.
But it's only off on certain parts. And it's not on every page. Some pages are perfect and others are off on half the page and, very rarely, the whole page is off.
Ok I have a question for my craft robo I followed the video perfect and everything and I installed the controller and iv lined up to the carrier sheet but when I go to cut it is saying its not reading my registration marks also when I go to cut and switch over to craftrobo from printer its not there but it will take me to the controller and I set it up rite and calibrate it to the rite position and its still coming up as a error and won't cut