UPDATE!!!
So I got the support off the print and I put it together for a test fit. Here is a quick pic of the Spoofer with the LCD screen in and on. I 3D modeled the dimensions just right so I don't actually have to fasten the screen in, it just kinda pops in there. Same with the magnets I used to attach the access panel.
And below, I took a quick video showing the innards of the spoofer and how it all goes together. My iPod was dead when I took this, so the video isn't going, but you can see where everything sits.
Let me know what you guys think. As always, questions, comments, critiques, all welcome.
So I got the support off the print and I put it together for a test fit. Here is a quick pic of the Spoofer with the LCD screen in and on. I 3D modeled the dimensions just right so I don't actually have to fasten the screen in, it just kinda pops in there. Same with the magnets I used to attach the access panel.
And below, I took a quick video showing the innards of the spoofer and how it all goes together. My iPod was dead when I took this, so the video isn't going, but you can see where everything sits.
Let me know what you guys think. As always, questions, comments, critiques, all welcome.
Last edited by a moderator: