I wanted to share with you guys a small project I finished up recently!
Its the data chip seen in the halo 5 teaser video, as soon as I saw this I thought it was too awesome not to build! so here it is!
First thing I did was draw up a 2D design for my rendition of the piece
I then imported it into solid works and made myself a nice 3d model to be sent off to shapeways!
problem was that the shapeways print turned out great on one half but the detail on the other half was lost
so i molded the good half of the chip
cast it twice and stuck them together then molded that as a master
I then cast a couple up with some cold cast iron!
Its the data chip seen in the halo 5 teaser video, as soon as I saw this I thought it was too awesome not to build! so here it is!
First thing I did was draw up a 2D design for my rendition of the piece
I then imported it into solid works and made myself a nice 3d model to be sent off to shapeways!
problem was that the shapeways print turned out great on one half but the detail on the other half was lost
so i molded the good half of the chip
cast it twice and stuck them together then molded that as a master
I then cast a couple up with some cold cast iron!
Last edited by a moderator: