Ok this is my first build. I downloaded this Mark VI Helmet (http://www.4shared.com/file/5cbjgOp8/MKV_Helmet_by_MOZ.html)
Now I open it up in PepaKura and the scale is (12.645611) which I printed and can tell it's too small.
I'm 6'2 and did the math according to a scaling post in here...
http://www.4shared.com/file/rjvd_bqA/H3_MK_VI_Helmet_by_Slyfo.html
Thats the site but I want to knowhow to doit myself pwease ;) I've seen tutorials where people had pieces cut out on one sheet, notone piece spread on to two sheets.
Ok so I finally figured out the scaling method by using inches/86 then times current scale which I gathered it's usually 31.9, ANYWHO
When I rescale and go into print preview I notice the pieces are too big. Isn't it suppose to FIT the pieces on what could fit on each paper? So please help a...