3d Printed Mark VI

ChuckyBoss25

New Member
Right. Third times the charm.

I’m not the most active on here, and I constantly forget to update, but it’s high time I double down on posting.

I am currently in the process of 3d printing Halo 3’s Mark VI. So far I have the front half of the cod piece assembled.

The under-suit is also figured out. I managed to grab a hold of the old Rubie’s Halo 3 deluxe suit. It’s warm, but it’s baggy enough (and the armor is scaled large enough) to have something like an ice water camel back.

That’s all for now. I plan on posting once the cod is fully assembled.
 

Attachments

  • 9F43FA47-9A42-40F6-9E16-752224C80B1F.jpeg
    9F43FA47-9A42-40F6-9E16-752224C80B1F.jpeg
    895.2 KB · Views: 47
  • 2A9B9E5E-9D59-4938-9C4A-062AE9415376.jpeg
    2A9B9E5E-9D59-4938-9C4A-062AE9415376.jpeg
    1.4 MB · Views: 45
This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

Top