Thanks! And true about the finishing, when I did my dragon priest mask I figure 90% of the time went into sanding, priming, sanding, priming and so on. But the finish when coating it with paint was very much worth it!
As far as print issues my Voron was just being a bit difficult, it had some layer shifts and eventually I had a cable that broke inside the drag chain. It's fixed now, I just haven't printed any more parts recently.
I'm also debating switching to PLA+ given that temperatures here in The Netherlands don't really hit that high, and I'm coating the armor parts with some epoxy anyhow. ABS seems like an unnecessary hurdle at this point.
