........

Status
Not open for further replies.
M

minijayne211

New Member
I am going to start my first suit of armor and whenever I go to show edge ID the numbers always overlap, does anybody know what is going on? I would appreciate it if someone could help.
 
You'd have to change the font size for the edge id numbers. Only problem is, they start to get impossible to read the smaller you go with them. That's your only option that I am aware of.
 
well they are pretty small as is so i guess I am going to have to deall with it because I have already started cutting and glueing.
 
Is the font size under print and paper settings? Because I have been cutting for a couple of hours now and I cant read half of them so I think im going to have to start over.:(
 
Status
Not open for further replies.
Back
Top