Aargh!

Status
Not open for further replies.

pcgamer15

New Member
The left bicep piece had some of it's flaps come unglued during it's first resing coat...
Is it still savable once it dries or would I have to make another?
 

AoBfrost

Well-Known Member
DId you use cardstock? Resin shouldnt make tabs fall apart unless they were weak, if you used paper, then blame yourself, if you used cardstock, then maybe the glue you used wasnt put on right or enough.
 

pcgamer15

New Member
AoBfrost said:
DId you use cardstock? Resin shouldnt make tabs fall apart unless they were weak, if you used paper, then blame yourself, if you used cardstock, then maybe the glue you used wasnt put on right or enough.
Yup, I used cardstock.

It could be that the tabs weren't glued enough...
Hopefully it's slavagable.
 
Last edited by a moderator:

Liamthedevastator

Well-Known Member
well it also depends, what did you use as the glue? The resin generates a fair amount of heat (which is how it hardens, its a chemical reaction) so the best glue to use is stuff like hot glue gun (low heat glues).
 

pcgamer15

New Member
Darkfire said:
well it also depends, what did you use as the glue? The resin generates a fair amount of heat (which is how it hardens, its a chemical reaction) so the best glue to use is stuff like hot glue gun (low heat glues).
Used hot glue as well.
Probably just didn't put enough on.
 
Last edited by a moderator:
Status
Not open for further replies.
Top