Armorsmith height

Catsbegaming24

New Member
Hello, I'm currently working on a custom halo reach suit using armorsmith. I have ran into a problem that when I do all my measurements my overall height ends up being 3-4 inches shorter then what I need to to be. I've reset my model/avatar multiple times and it always seems to default to the shorter size. How can I fix this?

Update : I just ran a few more tests and it's still a few inches off but it's higher rather than shorter now so I'm going to take what I can get.
 
Last edited:
This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top