barrel and pipe size for 3d Print SPNKR

[DanielPhoenix27]

I'm currently 3D Printing the M41 SPNKR (Reach Version) that was made by TheApropalypse.
the person who made the files has deleted the information on what materials I need to build it so what pipe and rod size do I need?

 

[SpartanSweed]

I would print off a small piece that goes around the PVC to find what you need

 

[PowerMaster MD]

I would print off a small piece that goes around the PVC to find what you need

Agree. Or use a cheap micrometer and measure the diameter- then get that size PVC or dowel.

 

[Shadowx00x]

I am also trying to build the same one from TheApropalypse and ran in to the same issue. I found the description of the deleted post. Here's the relevant section:

"The Rocket tubes require 2"diameter pvc pipe sections, 1/2 inch steel electrical
conduit tube was used for internal connectors, the rod holding the body together,
and the rod that runs along the barrel. A short section of 3/4" pvc is required for
the foregrip."

This is late, but hopefully will still be helpful.