Foam cosplay ODST in foam

[SpartanEC40]

Hello ! I wanted to know if of people could help for to do one attached for hang one handle (energy sword) of my plate of thigh (my plate east done in EVA foam) but without power see the fasteners and he should the take. I'm sorry if the text wanna nothing say

 

[Spartan 404]

Hello ! I wanted to know if of people could help for to do one attached for hang one handle (energy sword) of my plate of thigh (my plate east done in EVA foam) but without power see the fasteners and he should the take. I'm sorry if the text wanna nothing say

Are you asking about how you should mount the sword without fasteners? If so I'd suggest a high strength magnet, since it's eva foam you could probably even put it behind the foam for a pretty strong and invisible mount!

 

[SpartanEC40]

Vous demandez comment monter l'épée sans attaches ? Si oui, je vous suggère un aimant puissant. Comme c'est de la mousse EVA, vous pourriez même le placer derrière la mousse pour un montage solide et invisible !

Ok but I have fear that it breakage the foam (your cosplay is amazing !)

 

[Spartan 404]

Ok but I have fear that it breakage the foam (your cosplay is amazing !)

It won't break the foam unless if it's installed improperly, just ensure your rigging is good for your supports, and thank you brother

 

[Rigel17]

I agree with Spartan 404 with using magnets. My foam ODST as both a knife and a 3D printed SOCOM pistol on my thighs. The pistol weighs a couple pounds, likely the same, if not more than your energy sword handle, and not only is the magnet strength strong enough to hold it there while moving, but it is also quite easy to detach and reattach. Which was very helpful being hands free at lvl up expo a few weeks ago.
Here is how i did mine. The magnets are ceramic neodymium, 1inch wide, from amazon.