Halo Infinite Gravity Hammer Project

Unfit Armory

Member DIN
Hello! over the past few months I've been working on my biggest project yet, the Halo Infinite Gravity Hammer!!! I fell in love with the design recently and have decided to Model and print it. I am still working on refinements but it is super close to being done. I'm excited to show you all the progress on the print.
Screenshot 2023-08-11 073324.png
Screenshot 2023-08-11 073340.png
Screenshot 2023-08-11 073349.png
This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.