Health Pack / First Aid Kit

Drew

New Member
Here's the first aid kit I printed for my Rakshasa kit. I printed it in white to keep finish work minimal and then with the left over webbing from the armor build I made a little harness and a 3D printed buckle to hold it closed. I also put some EVA foam in it so I can put my phone in there without fear of it bouncing around. I found the file on thingiverse and scaled it up big enough for my phone.
IMG_7517.jpeg
IMG_7516.jpeg
IMG_7518.jpeg
 
Here's the first aid kit I printed for my Rakshasa kit. I printed it in white to keep finish work minimal and then with the left over webbing from the armor build I made a little harness and a 3D printed buckle to hold it closed. I also put some EVA foam in it so I can put my phone in there without fear of it bouncing around. I found the file on thingiverse and scaled it up big enough for my phone.
View attachment 360703View attachment 360704View attachment 360705
That's awesome , love it
 
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top