Helm visor

Status
Not open for further replies.

Chewy

New Member
I have my sexy motorcycle visor ready to put in my helm and I have an idea how I will put it in, but I would like to know the best, or most effieient, way to insert it and kepp it in sturdy.
 

Nomadic Spoon

Jr Member
Spase said:
Cut them to Fit, glue them in place... thats my advice
And don't attempt to power-drill-screw the visor in.

Most materials you are using do not like that sort of thing. :cautious:
 
Last edited by a moderator:

AoBfrost

Well-Known Member
If you wanna be cheap, leave an inch extra sitting on the insides of the helmet, duct tape that to the inside and make a nice duct taped inside, covers up the paint and resin fumes, or you could cut it to almost perfect size, leaving a ltitle off the edge and hot glue it in. I used industrial strength velcro just so when I wear one helmet I dont need to buy multiple visors, I can take a visor out of the helmet, put it into a new one easily and it fits perectly.
 
AoBfrost said:
I used industrial strength velcro just so when I wear one helmet I dont need to buy multiple visors, I can take a visor out of the helmet, put it into a new one easily and it fits perectly.
That is a very good idea. I might do that too.

I was just going to say hot glue....
 
Last edited by a moderator:
Status
Not open for further replies.
Top