Helmet Headphone Electronics Tutorial - Hearing Enhancement

is there anybody that can help me with this shooting headphones?
You're going to need to provide more information or explain what your issue is.
Are you having trouble sourcing or buying the head phones?
Do you need help with the wiring?
 
For those that have done this, have you ran into any issues with feedback from the microphone? I've been trying to determine if it's a mic placement issue picking up the speaker, or if I damaged something during disassembly.
 
For those that have done this, have you ran into any issues with feedback from the microphone? I've been trying to determine if it's a mic placement issue picking up the speaker, or if I damaged something during disassembly.
I haven't had feedback issues. Your mics might be too close to the speakers
 
For those that have done this, have you ran into any issues with feedback from the microphone? I've been trying to determine if it's a mic placement issue picking up the speaker, or if I damaged something during disassembly.
If you are still experiencing this problem you should post a picture of your board.
 
I'm assuming that it was a combination of the mic and speakers being too close and not having any foam helping isolate the two from each other, I'm still experimenting with placement of the components, but will update if I continue to have issues.
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top