I need your opinion!

[KrazyKid02]

OK i recieved the pep printouts from robo yesterday but the mountain and valley folds were the same so i was thinking that if i still folded it both ways then taped it with tape that holds well but you can still peel off and just put it together by pictures of it assembled then glue it as close as i can. Do you think that will work. Im open to any ideas.

__Krazy__
ps. girl scouts just came woohoo thinmints yumzz

 

[Twitchfmx8811]

ok
1. Dont use tape you will regret it big time
2. Go into the pep designer and open the file. Click Configuration at the top. Next click line style configuration. Set the mountain fold to 1.0 , 1.0 Then set the valley fold to 2.0 , 1.0 , 0.5 , 1.0

That should fix your problem.

 

[Falling Jihad]

ok
1. Dont use tape you will regret it big time
2. Go into the pep designer and open the file. Click Configuration at the top. Next click line style configuration. Set the mountain fold to 1.0 , 1.0 Then set the valley fold to 2.0 , 1.0 , 0.5 , 1.0

That should fix your problem.

do this with all of his beta files because when i started working on them the line config was different on some of the files. it got confusing fast.

Good Luck