Reply to thread

I've measured my head from chin to crown, nose to back, and ear to ear, but I'm not exactly sure how to translate my measurements to PepaKura.

Like I can adjust the scale of the entire model, overhang included, but all I have to go off of is my own head measurements. This kinda seems like a trial and error thing. Is there a solid method for figuring out what I need to set my model scale to based off of my head measurements?


This thread is more than 11 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top