Mech/Exoskeleton Build (Full-Size )

Power armor be lookin'

乇乂丅尺卂 丅卄工匚匚

pa1.jpgpa2.jpg

 
Taking a break from fabricating metal parts to figure out how to integrate computer controls into my mech projects... by building a workshop waifu: an emoting tool holder powered by raspberry pi.

workshop waifu.png

 
Working on the neck mechanism: it is so jiggly because it is thumbstick controls and I suck at those, and it is loosely taped to a board resting on my chair.


Skull

20220425_220352.jpg

The extended frame:

20220424_192915.jpg

Neck mechanism

20220428_201531.jpg

Abdominal frame:

20220428_201523.jpg

Covered and standing next to the powerarmor:

20220428_203024.jpg

Need to install the Raspberry Pi and finish up the servo controllers, then she is ready for the emotive programming!
 
Been watching this for like 3 years still loving the progress man, I know you been busy with your mechs but have you consider doing a javeline from Anthem, think it might be up your alley.
 
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top