Mirage core legs

caretaker08

Jr Member
Keeping with mirage core base I 3d printed all.the leg and boot parts. I covered every part with pasty dip and truck bed liners so I didn't have to sand bearly anything at all. Some parts of the print failed but we just cut the file and printed what failed and glued those together. With the pasty dip, truck bed liner and a bit of hiding skills you can hardly tell there is separation on a few prints. All parts are held to me by elastic bands except the knee pads which are sewed into a knee pad insert. The boots have everything shoe glued on.
 

Attachments

  • 20240714_152755.jpg
    20240714_152755.jpg
    1.5 MB · Views: 64
  • 20240714_165800.jpg
    20240714_165800.jpg
    3.2 MB · Views: 55
  • 20240714_165843.jpg
    20240714_165843.jpg
    2.9 MB · Views: 62
  • 20240715_164807.jpg
    20240715_164807.jpg
    3.1 MB · Views: 61
  • 20240715_182451.jpg
    20240715_182451.jpg
    5.5 MB · Views: 71
  • 20240717_002401.jpg
    20240717_002401.jpg
    475.9 KB · Views: 68
  • 20240717_002445.jpg
    20240717_002445.jpg
    579.4 KB · Views: 69
  • 20240717_002601.jpg
    20240717_002601.jpg
    1.2 MB · Views: 66
These looks SO GOOOD! The fit is really good too. Btw you also look amazing with this armor set! You make it look so good that I want one lol
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top