Reply to thread

Thank you. This week I've been racking my brain on the plumbing for the needle retraction system. When you shove the needles all the way under the shroud, there's not a lot of room for the mechanism left. Still using stepper motors, but dropping the belts for synchromesh cables.

Redshirt

Guess who's not coming back from the Slayer match--the guy in the Red Shirt

Signature Project:  Halo 3 Working Airsoft Spartan Laser in Metal & Fiberglass


This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top