Pepa H3 AR *Project Complete pg. 7*

Status
Not open for further replies.

Sigma LS

Sr Member
Pepa H3 AR *New Pics pg. 6*

There are a few similar files around but I thought I'd share this one.

This is a fanmade MA5C AR model that I've modified for pepakura. This thing has lots of folds but is very do-able. I 'll put up my own progress on it when I'm further along (actually get started ;-) ).

AR.jpg


Model
http://files.filefront.com//;8290803;;/

Texture
http://files.filefront.com//;8290810;;/

Correct scale is 2401.948

I also have the H2 sword that I'll put up here in a little bit.
 
That would be awesome red.

Just imagine a pepa Brute Spiker :wowie:
And who knows what he has that was hiding in the Beta :shifty ninja:
 
nice but wen u go into pep and turn on the edge id its a nightmare, other than that its perfect i can even get all the peices on seperate pages,, verry nice

_____________________________
Ragtagsoldier.png
 
Alright, I have a question:

My printer cuts off the very edge of the page, even when margins are set to 1. So I can't make things that have pieces on more than two pages. Can someone "cut" the pieces into 1-2 pages each?
 
plant the c4 in the cpu, but make sure the fan wire is disconnected and put the wire in the plastic, ne ways there should be a button that says no margins
 
Damien said:
plant the c4 in the cpu, but make sure the fan wire is disconnected and put the wire in the plastic, ne ways there should be a button that says no margins


Nope nouthign any one have a screenie of were it is at
 
Last edited by a moderator:
I believe 15mm is the smallest margin you can do in pepakura, just set it to that in print and paper configuration.

Oh, and I forgot. The mag is removable.


ARclip.jpg
 
Status
Not open for further replies.
Back
Top