Pepakura- PRINTING HELP NEEDED. Please.

[Popeanator]

I followed part 2 of the Hero Tutorials, but I still can't seam to get it to print properly.

Hero Tutorials vid

I live in Australia so we use the A4 paper size.
All I get is weird numbers printing like this-

This is the printer i'm using- HP Deskjet F380.

Any help would be great as I can't really make much without it. I've started some EVA foam Mass Effect guns. But I really want to make some Armour pieces as well.

Please Help, I'll try anything.

 

[BiGHARYSCOTSMiN]

IF you are getting just the flap numbers and no lines, go into "print preview" and try that... if you're on Pepakura Designer 3.

Basically what I do on EVERY file I try to print, I do cleaning up and all that jazz, and then go into PRINT PREVIEW and set black/grey scale (Black & White only mode) and print away.
It worked for me, give it a one page test run and tell me what happened!

I wish we had more Vauxhalls in the US lol
Yeah I'm a car FREAK

 

[Popeanator]

That was quick! Unfortunately ran out of INK for the printer yesterday, I'll have to by some from the shop. Thanks!

 

[Popeanator]

I played around with the settings changed it from Bitmap to Vector and works perfect.

 

[Croc co]

lol the collums are the layout of the pep pieces in pep designer, say you have an elite helmet it has 2 collums across and 5 down, that page specifies what page it is, and its location

Edit! I to live in aus, there's no fiberglass here though... yet!

Edit edit! 400th post