Plasma Pistol v1

[SpartanSweed]

It’s been a good while since I’ve last posted, busy with life and all that, but I recently bought a 3D printer! I can’t wait to see what all I’m gonna make with it, but I decided to start small (technically).

I nabbed a plasma pistol model off thingiverse and ran into a few problems. All three pieces were warped in one area. Since adding a raft these issues have been fixed thankfully.

I’m about halfway through the pistol as of writing this. Never realized how much I dislike waiting for prints to finish. Hope to keep y’all updated soon!

 

[SpartanSweed]

Few more updates, everything is printed and put together!

 

[InterfectorF]

Looks promising! What will you use to fill up the seams?
Its a shame it was taken apart so rigidly as opposed to along seam lines in the model.