Practicing on my modelling on weapons

Thread starter JDTV
Start date Sep 29, 2025
Tags

#3d print #3dmodels #haloinfinite #weapon

JDTV

New Member

Sep 29, 2025

Been wanting to get my own 3d modeling/printing site for people around europe, i havent used a single bit of measuring and just used two images for both guns then compared it to a actual 3d model and go the thicknesses right, Tell me id it looks good and any recommendations, the website i use to model is Sketchup, Bandit/DMR without scope (ill model the scope so i can change from halo reach to infinite) and Sidekick

This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.