printer down scale question

SPARTAN 094

Active Member
when ever my I want to print it says A part of development may not fit into pintable area adjust scale? Yes No

What do I do??!?!??!!?
 

SPARTAN 094

Active Member
BloodyShadow13 said:
rearange your parts to fit on letter size paper. then set pepakuras print settings to letter
I have but still says it EDIT: Im printing foot and thats why
 
Last edited by a moderator:
it only does that if your pepakura print settings are still at a4. ajust pepakura print settings.

goto file/print and paper configuration and change where it says a4 to letter.
change from portrait to landscape too.

also go to file/printer setup and change from portrait to landscape
 

SPARTAN 094

Active Member
BloodyShadow13 said:
it only does that if your pepakura print settings are still at a4. ajust pepakura print settings.

goto file/print and paper configuration and change where it says a4 to letter.
change from portrait to landscape too.

also go to file/printer setup and change from portrait to landscape
I did that but im printing the foot so the foot doesnt fit on 1 piece
 
Last edited by a moderator:

SPARTAN 094

Active Member
BloodyShadow13 said:
split it up then. have you used pepakura before?
if not then please read the tut stickied in this forum.
I did but I didnt slip up but it worked
 
Last edited by a moderator:
Top