1st Build Rakshasa update

John7j

New Member
1000007367.jpg

Finally after many failed prints, my Rakshasa chest plates and harness have printed well enough to be worked on. Yes, that is a Breach Collar kit in the chest. I'm pretty pleased with it.
 
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top