Props The Foamsmith back to work

rickrtickr

Well-Known Member
Member DIN
S259
Well, it has been a hot minute, but I am starting to get somewhat back into the swing of things again.

And I had this feeling like I needed to revisit some of my past projects for renewal.

And while I already have a great place to showcase my armor reconstruction, it is time to showcase some of the prop and external projects that aren't armor.

And I figured that the best place to start would be my SAW. My old one took an unfortunate tumble off my gun wall and broke. So I might as well start there.

Have a couple pictures:
20250418_145616.jpg
20250418_145625.jpg
20250418_171532.jpg
20250418_171539.jpg
 
Well this will be a little bit of a smaller update but it is an update.

Now that I have the base of the gun cut out and prepped, I need to build and install any of the internals that I might want.

And this is just the first one:

20250511_165336.jpg


Do you have a guess?

20250511_165345.jpg



How about now?

20250511_165452.jpg


Maybe now it is a little more clear! Yep I am building the charging handle! The main assembly is complete and I only need to add the handle itself (3d printed) and I will be able to get it put into the prop!

I have at least 1 other piece of internal hardware that I intend to add: a moving trigger.
and 1 optional piece: I have a small motor that I might create a "tumbler" for the gun so that it will vibrate when the trigger is pulled!

But we will see how ambitious I get.

Well that is all for now.
 
This thread is more than 3 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top