Ok so it's definitly been awhile but I'm back and ready to go. So far I've just given up on my helmet and chest piece until I can find a way to make them fit or to get them on in pieces. So I've "finished" my hand plates and have just printed the fore arm and hopefully it will fit no prob (gonna need to alter it a little). But besides that my next few steps will be;
-Fore arms
-Shoulders
-Shin
-Thigh
-Cod (possibly adding pockets for phone)
-Boots (any suggestions on type of boot/shoe)
-Chest
-Helmet
In that order
Last note does anyone have any suggestions on types of gloves I'm gonna use Velcro to attach the hand plates. And do I need to reinforce the hand plates?