Reply to thread

Message

First small up date to follow along.

I took the bicep plate that used for the first set of Yoroi (acquired from Titlewave) and modified them a bit. I cut off the bottom plate and removed the lace sections on the original model, I then added a second row holes on the bottom to be used as the middle and top plates.
[ATTACH=full]349237[/ATTACH][ATTACH=full]349238[/ATTACH]

While not a perfect job it did give me the result I wanted when I printed them.

[ATTACH=full]349239[/ATTACH]

Ill need to find a lace that matches the color I want still but for the prototype parts it was a good first attempt.

[QUOTE="Emp Frosty, post: 845262, member: 21924"] First small up date to follow along. I took the bicep plate that used for the first set of Yoroi (acquired from Titlewave) and modified them a bit. I cut off the bottom plate and removed the lace sections on the original model, I then added a second row holes on the bottom to be used as the middle and top plates. [ATTACH type="full"]349237[/ATTACH][ATTACH type="full"]349238[/ATTACH] While not a perfect job it did give me the result I wanted when I printed them. [ATTACH type="full"]349239[/ATTACH] Ill need to find a lace that matches the color I want still but for the prototype parts it was a good first attempt. [/QUOTE]

This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification