What i was working on for the last 2 months

Status
Not open for further replies.

CyberBen

Active Member
The legendary edition from Halo 3 on the Right and my Helmet on the left. I call it the "Mythic Edition" :p

There is 4 10mm LEDs outside, 3 inside 3mm, 2 small fans. all this on 2 12v circuit, one for the LEDs and the other for the fan's. The helmet with the batteries weight 1.3 Kilo(± 3 pounds).
IMG_1127.jpg


Details in the back.
IMG_1131.jpg


Right side and under the bill.
IMG_1132.jpg


With the lights turned on.
IMG_1128.jpg


Again but no flash.
IMG_1129.jpg


This is a M6D Pistol, I bought on eBay after a lot of sanding, spot putty, rework the grip(bad alignment from the mold), change the big adjustment screw on each side to a more accurate one and a nice paint job. :cool:
IMG_0942.jpg


IMG_0940.jpg


IMG_0941.jpg


That's it for now.
 

Attachments

  • IMG_1127.jpg
    IMG_1127.jpg
    38.8 KB · Views: 179
  • IMG_1131.jpg
    IMG_1131.jpg
    30.8 KB · Views: 179
  • IMG_1132.jpg
    IMG_1132.jpg
    41.6 KB · Views: 164
  • IMG_1128.jpg
    IMG_1128.jpg
    27.4 KB · Views: 178
  • IMG_1129.jpg
    IMG_1129.jpg
    33 KB · Views: 174
  • IMG_0942.jpg
    IMG_0942.jpg
    32 KB · Views: 171
  • IMG_0940.jpg
    IMG_0940.jpg
    27.3 KB · Views: 169
  • IMG_0941.jpg
    IMG_0941.jpg
    33.6 KB · Views: 163
So all this took you about two months? The helmet itself ((mythic)) is quite nice, its "smooth" haha for the lack of a better word. Keep up the good work! :3

Also....why hasnt anyone else commented? Please people, S-U-P-P-O-R-T!!! haha just showing support and i may have just humiliated myself in the process.
 
Nice job! Keep it up! By the way the helmet next to your legendary one, it looks very similar to the legendary .Correct me if I'm wrong though.
Once again great job!
 
Nice job! Keep it up! By the way the helmet next to your legendary one, it looks very similar to the legendary .Correct me if I'm wrong though.

Thanks, if you think I just repainted a Legendary helmet then it mean I did a great job. :cool:
 
damn cool, fully hi detail
is that full resin?

I did it the old fashion way ;)

Pep, resin, fiberglass inside, sanding outside, bondo/rondo, more sanding, painting, dual visor fitting, LEDs/fan soldering and padding.

All this took ± 100 hours of work
 
Status
Not open for further replies.
Back
Top