Build Update:
Printing:
I got a lot more printing done today than I thought I would. Some family plans canceled and I ended up getting the whole base printed. First I printed the Docking test piece. I wanted to make sure the chip fit right before I started a really big print.
Fits Like a glove:
The I printed the internal pieces that nobody cares about:
Then it was time to print the base. I used a fairly large brim since the bottom cross section is so small.
And finally, the top piece:
Sanding:
I've started sanding and filling the final chip pieces, Probably one more good pass, then cleanup and paint.
I've also started sanding on the base. I printed the base at a .2mm layer height, so it is not as fine as the chip. A little more elbow grease may be required.
Painting:
Nothing major here, I just did a quick test shot on two non-sanded reject pieces to see how the color comes out and to give me something to practice on. I'm liking the gunmetal color on top. A little weathering and I think it will be good.
Anyway, sorry for all the pics, but things have been moving along.