Flaminshotgun
Member
So I have used the pepakura and fiberglass method to make a whole suit of armor. So now I've started painting, started with a base coat of black spray paint on the chest. However I have ran into an issue. I have a series of uneven grooves and drops all around the chest plate (see pictures). I assume this is because of the epoxy resin applied to the outside of the armor, it must have been uneven. So I think I have two options, 1. Attempt to sand the whole chest plate down and then repaint it. 2. Remake the chest plate out of foam hoping that leads to a more consistent texture.
I wanted to know if anyone has experience with this issue and had any advice to supply.
I wanted to know if anyone has experience with this issue and had any advice to supply.