Starting with the L3X unfold of the CQB. (Same one that vshore100 used). Im wondering if, when i get to the finerglass stage, i can keep the top and bottom half separate until after fiberglassing to make easier to work with. Thebottom half is nearly done, and I'm starting on the top half.
As you can see i am not particularly good at pep yet and i was forced to use two different colors of cardstock when I ran out of white during printing.
Any and all advice is greatly appreciated.
As you can see i am not particularly good at pep yet and i was forced to use two different colors of cardstock when I ran out of white during printing.
Any and all advice is greatly appreciated.