Recent content by bfolkrod

Name: --- (I don't like putting my name up online. Just for safety! :D ) Profession: Don't have one! Age: 13 (20 day's till' I'm 14) Favorite Hobby: Piano, Videogame's (can't choose) Favorite part of halo: The part where you escape in a warthog as the planet is falling apart! at the end of...

Good reference to know! :D Thx

Ahhhhhhhhhhhh. I see....well From the information I have gathered so far I am probably considering adding the paper visor section in and then cutting it outwith a dremel,sanding. (blah blah blah etc' etc'.) My motto actually is "Better safe then sorry." So I guess I should probably stick to it...

Once again..THANKS :D So I did describe the process of fiberglassing correctly? Did you still print out the page with the paper visor on it or did you remove it (using/inside the Pepakura Designer/Viewe)before you printed it? (obviously (once again) using/inside the Pepakura Designer/Viewer)

Thanks! Isn't fiberglassing the part where you place chunks of fiberglass mat into the inside of the armor? and then resin that over? if it is then wouldn't it be hard to cut out that section afterwards? And finally...Is warping when something seems to droop,bend or appear distorted? (Sorry I'm...

In the Master Chief Helmet File I am using (AND IN ANY MC HELMET FILE) it seems that in the area where the visor is set, it is covered in paper? Is that how it's suppose to be?/do I have to cut it out once it has been completely built?/Do I just avoid building that section when building the...