Recent content by RGRthomas

  1. R

    First Build. Mk VI WIP

    Over the weekend I started fiberglassing (I've never done it before) and the part of the helmet that wraps around your mouth and nose got extremely warped. So I am remaking the helmet....again.
  2. R

    First Build. Mk VI WIP

    Just a little update on what I've been doing this week. Just finished redoing the helmet a few minutes ago. I'll probably fiberglass the helmet and chest this weekend. Just ordered a pressure suit from six six one yesterday. But I do have a question about the visor. Do they come in...
  3. R

    First Build. Mk VI WIP

    Thanks everyone! CoolC: You are correct the torso is from Flying Squirrel. And yeah I was looking at the brim and going to use electrical tape to hold it down. However last night I left the helmet in a bad place and apparently the dog thought it looked pretty tasty. I'll be redoing it...
  4. R

    First Build. Mk VI WIP

    From start to finish it took me about 3 days. And I agree it does seem to go faster without the numbers.
  5. R

    First Build. Mk VI WIP

    Thanks for the compliments. And yeah I was pretty nervous about doing it with no edge ID's but on some of the peices they made it impossible to see the cut/fold lines.
  6. R

    First Build. Mk VI WIP

    Been working on this all weekend. There's a little warpage on the chest that I need to fix. Any advice, observations, or constructive criticism is welcome. Thanks.
  7. R

    Complete Pepakura Viewer for CraftROBO guide/FAQ

    Yep I didn't have the driver it was still giving me trouble so I had to install it manually but It's working perfectly now. Thank you for the help.
  8. R

    Complete Pepakura Viewer for CraftROBO guide/FAQ

    I just got the Silhouette SD and I'm having trouble getting it set up as a printer device can anyone help on this?
Top