1st 3D printed build (other two were EVA)

Deltaraven

Jr Member
Thanks, ill have to check them out. There's areas where I wouldn't mind putting lights on and definitely fans.
Super easy! And super cheap to build. I want to add magnets to my armor to hold things as well. I have been learning to plastic weld into my 3d prints. I also did the same for the lights, so you don't see as many wires. My dream is to have my weapons just cling to my armor.
 

Spartan Khan

Member
its done ill pic dump, yea one of the shoulders started to come off, im aware.
g.jpg
 

Attachments

  • 296029618_1122461848304498_9116168059646178105_n.jpg
    296029618_1122461848304498_9116168059646178105_n.jpg
    594.7 KB · Views: 10
  • 295521430_558474952684283_6322258933630024540_n.jpg
    295521430_558474952684283_6322258933630024540_n.jpg
    689.4 KB · Views: 12
  • 294954063_726290631790233_103796545009647393_n (1).jpg
    294954063_726290631790233_103796545009647393_n (1).jpg
    575.4 KB · Views: 12
  • 294841106_1166931810532248_727890116458216428_n.jpg
    294841106_1166931810532248_727890116458216428_n.jpg
    550.8 KB · Views: 12
  • 294821560_1206767260110781_7154541486651384126_n.jpg
    294821560_1206767260110781_7154541486651384126_n.jpg
    910.2 KB · Views: 14
  • 294509708_1772581636422668_7851708290499295270_n.jpg
    294509708_1772581636422668_7851708290499295270_n.jpg
    819.5 KB · Views: 11

Deltaraven

Jr Member
Don't mind my bathroom !!! I am working on my Noble Six for Comic Con.
Too hot for neck cover, am getting the top all tight and snug.
Thighs, Knees, Calf, Boots, and everything else is done, just need to fit it all.
 

Attachments

  • 20220729_204343.jpg
    20220729_204343.jpg
    793.7 KB · Views: 12
  • 20220729_204512.jpg
    20220729_204512.jpg
    586.6 KB · Views: 12
  • 20220729_204453.jpg
    20220729_204453.jpg
    639.8 KB · Views: 16

Your message may be considered spam for the following reasons:

Top